To Next PageTo Next Page
Need help?Do you have a question about the JVC RX-778VBK and is the answer not in the manual?
General| Power Output | 100 watts per channel (8 ohms) |
|---|---|
| Frequency Response | 20Hz to 20kHz |
| Input Impedance | 47 kΩ |
| Signal-to-Noise Ratio | 100 dB |
| Dimensions | 17.3 x 5.9 x 13.4 inches |
| Weight | 18.5 lbs |
| Input sensitivity | 200 mV |
| Tuning range | FM: 87.5 - 108 MHz |
| Signal to noise ratio | 100 dB |
| Video Connections | Composite |
| Speaker Impedance | 6 - 16 ohms |
Advice to prevent electrical shock, fire, and exposure to rain or moisture.
Guidelines for proper air circulation around the receiver to prevent overheating.
Description and location of buttons and controls on the receiver's front panel.
Identification of buttons and functions on the supplied remote control.
Detailed guide on connecting front, rear, center, and subwoofer speakers.
How to turn the receiver on, off, or into standby mode.
Methods for choosing the audio or video source to play.
Setting speaker sizes (Large, Small, None) for optimal DSP performance.
Adjusting delay times for center and rear speakers to match listening position.
Setting crossover frequency and attenuating low-frequency effects for small speakers.
Introduction to 3D-PHONIC modes for immersive surround sound effects.
Explanation of Digital Acoustic Processor (DAP) modes for realistic acoustic environments.
Details on Dolby Surround and JVC Theater Surround modes.
Fine-tuning the effect level for 3D-PHONIC sound modes.
Adjusting speaker output levels and effect levels for DAP modes.
Adjusting speaker output levels and test tones for surround modes.
Steps to activate and cancel Dolby Pro Logic, Dolby Digital, and other DSP modes.
Controlling JVC components remotely and using automatic source selection and power.
Setting up and understanding the features of the TEXT COMPU LINK system for disc information.
Diagrams and instructions for connecting video components for AV COMPU LINK control.
Using the remote to control amplifier functions like surround modes and SEA settings.
Configuring the remote to control TVs from different manufacturers.
Setting the remote to operate CATV converters and DBS tuners from various brands.
Configuring the remote to control VCRs from different manufacturers.
