JVC RX-807VTN

—_
4
00
2
2
N
oO
o
oo
a)
= How to cancel programmed signals
Canceling ali the signals stored for a mode of the PROGRAMMABLE
CONTROL SECTION keys, or canceling the operation procedure
stored with the SEQUENTIAL PROGRAM keys.
1 » Press the LEARN key
-—=- =
ro Lights
‘a NZ OFF
2. Press the CANCEL key
‘tien
O) ~ Lights Lights
Ne Nand
-oo- -e-
Press the desired key for cancellation
Press the key
OFF OFF
=— co
SEND/LEARN ERROR
The ERROR indicator
lights when there
is no signal to be
canceled.
Blinks
serbiee ad sect
oy oeeC—eoe
Blinks
bd .
y
© ee
Canceling completed
Release the key.
@ When cancelling is completed, the remote controller exits from
CANCEL mode, and enters the LEARN mode.
32
3. Press the LEARN key
nme
This resets the Remote Control unit to the USE mode
®@ if you cancel a signal programmed in a key having a signal preset,
the key will be reset to the preset signal and further cancellation
is inhibited
Notes:
@ NEVER REMOVE THE BATTERIES while a canceling operation is
in progress. If normal operation is not possible even when, hav
ing removed the batteries by mistake, they have been reinstalled,
remove the batteries and leave the RM-SR807U for about 12
hours. In this case, normal operation will be restored but all the
stored data will be cancelled and will be have to perform program-
ming operations again
= PROGRAMMABLE CONTROL SECTION
Other remote control signals for each equipment can be memorized
with the PROGRAMMABLE CONTROL SECTION keys. (Use the
Function Select keys for switching the functions.)
Complete the following columns with the memorized signals:
VCR 1
NLAZLO8-Xu