JVC RX-807VTN

RX-807VTN
Disassembly Procedures
—
_
. Remove 2 screws located on the top of rear
. Remove 4 screws on both sides.
. Slightly open both sides of the top cover to
. Remove the top cover.
. Remove 3 screws © on the upper part of
. Remove the front panel.
. Remove the front panel.
. Remove 2 screws ©.
. Remove the all connectors.
. Remove the top cover and the bottom
. Unsolder the defective power transistor.
. Remove the screw holding the power
. Removing the P.C.B (ENH-204-2) .
. Unsolder the defective rear amplifier.
. Remove the screw holding the rear
® Front Panel
Removing the top cover
panel.
the left and right, and raise the rear side.
Then slowly lift it up and straight backward.
Removing the front panel (Fig 1,Fig 3)
the front panel. and 4 screws from the
lower part ® .
Removing
the
FL
Display
PCB
(Fig
4)
Fig
1.
Top
View
Except for the U.K,Germany,Continental Europe
Removing the bottom plate (Fig 3)
O goo D0O9000
.
Remove
14
screws
©.
C.00D000%00
Removing the power transistors
(For the Main & Center amplifier)
plate.
transistor using a pair of pliers, a wrench or
a bent screwdriver.
Removing the rear amplifier
(«PC1188H for the rear amplifier)
amplifier using a pair of pliers, a wrench or
a bent screwdriver.
PHONES
Fig 4. Front P.C. Board(END-155-1)
1-20 (No. 20333)