JVC RX-807VTN

(CEEOT ON)
~L
ldeimoreConvolnits we oe Soe, ce ol (Ofeyarece) Mm elAlnS ; :
The remote contro! unit provided control the receiver and JVC's audio
visual gear from a remote place
* Itis programmable, with the ability to learn the functions of most
other remote controls for audio and video components, regard-
less of make.
* It’s sequential programming facility lets you assign a sequence
of actions to a single key and up to three sequences can be
programmed
¢ The remote control unit also has two control panels: the external
panel has keys for basic operation and easy-to-use multifunction
cursor keys, while the internal contains keys for programming.
Jve ror ex-s0ry “ME
fee-sR807U REMOTE. CONTROL
@) SEND/LEARN indicator
ERROR indicator
The remote contro! unit operation statuses are indicated
@ VOLUME (-, +)
Press to adjust the output sound level.
@ REAR (-, +}
Press to adjust the output fevel of the rear speakers.
= Controls on the External Panel
Contains keys used in basic operations.
@ POWER
AUDIO: Press to turn the power for the receiver ON or STANDBY.
TV: Press to turn on or off the power to JVC’s TV receiver.
VCR: Press to turn on or off the power to JVC's VCR
@® SEQUENTIAL PROGRAM KEY (A. B, C)
The remote control unit functions can be stored in the desired order
for up to 16 individual operations
@©® SLEEP
Use this control when you want to set the Sleep Timer
@ SURROUND ON/OFF
Turns the surround sound effect ON or OFF
SEA ON/OFF
Turns the S.E.A. feature ON or OFF.
@ SEA PRESET
Calls an S.E.A. preset pattern
SEA CONTROL
Puts the Multi Function Cursor Keys in the S.E.A. mode
@ CSRP
ON/OFF: Turns CSRP ON or OFF
DISPLAY: Use to display the CSRP settings
@ Source Select keys
Press to change the source selected for input to the receiver
Different functions are assigned to the Multi Function Cursor Keys
depending on the source
@® Mutti Function Cursor keys
Use for basic operations of the source equipment selected with
the Source Select keys, and operation of the S.E.A.
MUTE
Press to turn the output sound ON or OFF
= Controls on the internal Panel
Extra keys on the panel are for the various operations that cannot
be done using only the keys on the external panel.
@ LEARN, CANCEL
Use to set the operation mode to LEARN or CANCEL.
@ Function Select keys
Press to select the function mode of the PROGRAMMABLE
CONTROL SECTION keys.
@ PROGRAMMABLE CONTROL SECTION keys
Use to operate equipment connected to the receiver.
Different functions are assigned to these keys by the Function
Select keys and Source Select keys.
Other remote control signals can be registered to these keys.
@ Inserting Batteries
Use long-life dry cells, type ‘AAA’ (1.5 V) x 2.
1. Remove the rear cover of the remote control unit by pressing down
gently while sliding it out
2. Insert the batteries, making sure that their position matches that
of the diagram inside the remote.
&
oe
3. Replace the rear cover
Battery Replacement
@ if the range of the remote seems shortened, the batteries may
be old. Try replacing the old batteries
@ Do not use a new battery with an old battery.
®@ Do not allow more than 3 minutes for battery replacement to
preserve stored data.
@ Use batteries of the same brand. Batteries can vary in voltage even
though they look alike.
@ |f you are not planning to use the remote control for an extended
period of time, remove the batteries.
CAUTION:
Do not heat batteries or attempt to dispose of them by burning.
in
NLAZO8-X¥u