To Next PageTo Next PageWhat to do if JVC RX-ES1SL remote control does not work?
If your JVC Home Theater System remote control isn't working, first ensure there's nothing blocking the remote sensor on the unit. If that's not the issue, try replacing the batteries. Finally, make sure the mode selector is in the correct position.
Why is there no sound from my JVC RX-ES1SL speakers?
If you're getting no sound from the speakers of your JVC Home Theater System, start by checking the speaker wiring to ensure all cables are securely connected. Then, verify that you've selected the correct source and that muting is not activated. Also, confirm that the input mode (analog or digital) is correctly selected and check all other connections.
What to do if JVC RX-ES1SL Home Theater System turns off after turning on?
If your JVC Home Theater System powers on briefly but then turns off and the STANDBY lamp lights up, it could be due to overloaded speakers from high volume or a short circuit at the speaker terminals. First, turn off the unit, stop the playback source, and turn it on again, adjusting the volume. Then, check the speaker wiring. If the wiring isn't short-circuited, consult your dealer.
Why is there continuous hiss during FM reception on my JVC Home Theater System?
If you're experiencing continuous hiss or buzzing during FM reception on your JVC Home Theater System, it could be due to a weak incoming signal. Try connecting an outdoor FM antenna or contact your dealer. It may also be that the station is too far away, so try selecting a new station. Also, make sure you have the correct antenna and that all antenna connections are properly connected.
Why is sound coming from only one speaker on my JVC Home Theater System?
If you only hear sound from one speaker on your JVC Home Theater System, the balance might be set to one extreme. Adjust the balance properly.
Why surround mode cannot be selected on JVC RX-ES1SL Home Theater System?
If you can't select surround mode on your JVC Home Theater System, check the speaker setting. The surround mode may not be available on the software being played back, or only the front speakers are set for use.
Why DSP mode cannot be selected on JVC RX-ES1SL?
If you can't select DSP mode on your JVC Home Theater System, check the speaker setting. The DSP mode may not be available on the software being played back, or only the front speakers are set for use.
What causes cracking noise during FM reception on JVC RX-ES1SL Home Theater System?
If you notice occasional cracking noises during FM reception on your JVC Home Theater System, it may be due to ignition noise from automobiles. Try moving the antenna farther from automobile traffic.
General| Channels | 5.1 |
|---|---|
| Audio Formats Supported | Dolby Digital, DTS |
| Tuner | AM/FM |
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | 100 dB |
| Speaker Impedance | 6-16 ohms |
| Type | Receiver |
| Inputs | 1 x Optical, 1 x Coaxial |
| Outputs | 1 x Subwoofer |
| Input Sensitivity/Impedance | 200 mV/47 kΩ |
