—22—
Page 22 December 26, 2003 2:23 pm
Changing Remote Control Code
This Remote is capable of transmitting two control codes; one set
to respond to A code control signals and another set to respond to
B code control signals. This Remote control is preset to send A
code signals because your VCR is initially set to respond to A code
signals. You can easily modify your VCR and the Remote to
respond to B code signals. When using two JVC VCRs, set two
VCRs and their Remotes to different codes, so that you can
operate these VCRs separately.
A Set remote control code for Remote
A Press and hold A/B.
B Press the Number key “2”.
C Press OK, and release A/B.
● The Remote now can transmit B code control signals.
B Check remote control code for VCR
Press and hold 4 on the VCR for more than 5 seconds while the
VCR is turned off. The code currently set appears on the display
panel.
C
Change code for VCR
Press any key on the Remote. The VCR now responds to B code
control signals.
● To set the Remote and the VCR back to A code control signals,
repeat the same procedure as shown above except pressing the
Number key “1” in step B of 1.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote control
code for the Remote between A and B (
墌 step A), keeping two
VCRs to different control codes.
● To change only the remote control code for the Remote, DO
NOT perform steps B and C.
Editing with Another VCR
You can use your VCR as the playback or recording VCR. You can
use a camcorder as the playback VCR and your VCR as the
recording VCR. Refer also to the other components’ instruction
manuals for connection and its operations.
A
Make connections
Example 1
● If another VCR is monaural, connect this VCR’s AUDIO L IN (or
OUT) connector to the audio output (or input) connector on
another VCR.
Example 2
(Ex.) To set Remote to B code:
MBR SET
A/B
2
OK
3
E
N
T
E
R
/
O
S
D
Hold
down
Press in succession
Release
Editing
To audio/video input,
S-Video input
This VCR
Another VCR
To AUDIO/VIDEO IN,
S-VIDEO IN
To AUDIO/VIDEO OUT,
S-VIDEO OUT
To audio/video output,
S-Video out
When using
this VCR as the
recording VCR,
connect this
VCR’s AUDIO/
VIDEO IN
connectors to
the audio/video
output
connectors on
another VCR.
When using
this VCR as the
playback VCR,
connect this
VCR’s AUDIO/
VIDEO OUT
connectors to
the audio/
video input
connectors on
another VCR.
S-video
cable
(supplied)
Audio/Video
cable
(supplied)
To S-video output
This VCR (for recording)
Camcorder
S-video cable
(supplied)
To AUDIO input
To S-VIDEO input
Audio/Video cable
(supplied)
To audio output
Player
SR-V101US.fm Page 22 Friday, December 26, 2003 2:24 PM
To Next Page
Loading...
