(No.MB393)1-15
3.1.11 Removing the power transformer
(See Fig.17)
• Remove the metal cover.
(1) From the top side of the main body, remove the tie bands
and wire clamp bundling the wires.
(2) Disconnect the wire from the connector CN952
on the
transformer board.
(3) Disconnect the wire from the connector CN102
on the main
board.
Reference:
After connecting the wires to the connectors, bundle the
wires with the wire clamps and new tie bands as before.
(4) Remove the four screws S and take out the power trans-
former from the main body.
Fig.17
3.1.12 Removing the front board
(See Figs.18 and 19)
• Remove the metal cover and front panel assembly.
(1) From the front side of the front panel assembly, pull out the
volume knob in the direction of the arrow. (See Fig.18.)
(2) From the inside of the front panel assembly, remove the six
screws T attaching the front board. (See Fig.19.)
(3) Take out the front board from the front panel assembly.
Fig.18
Fig.19
Transformer board
Main board
Tie
bands
Power transformer
CN952
CN102
Wire clamp
S
S
S
Front panel assembly
Volume knob
Front board
Front panel assembly
T
To Next Page
Loading...
Need help?
General
