JVC UX-A3 User Manual

e Do not use the unit at excessive high or cold
temperatures. The recommended temperature
range is from 5°C (41°F) to 35°C (95°F).
e After playback, unload the disc and close the CD door.
If mistracking occurs during play, lower the volume.
® Mistracking may occur if a strong shock is applied to the
unit or if is used in a place subject to vibrations (i.e. ina
car travelling on a rough road).
CD/TUNING/TIMER
Ke >>]
DOWN,
Skip playback
e During playback, it is possible to skip forward to the
beginning of the next tune or back to the beginning of
the tune being played or the previous tune; when the
beginning of the required tune has been located, play
starts automatically.
To listen to the next tune ...
Press the b> button once to skip to the beginning of the
next tune.
CD/TUNING/TIMER
ea Pl
To listen to the previous tune ...
Press the @«@ button to skip to the beginning of the tune
being played back and press again to skip to the beginning
of the previous tune.
Search playback
(to locate the required position on the disc)
e@ The required position can be located using fast-forward
or reverse search while playing a disc.
pons Mer Keep pressing for
fast-forward search
Keep pressing for
fast-reverse search
DOWN UP
@ Hold down the button; search play starts slowly and
then gradually increases in speed.
® Since low-volume sound (at about one quarter of the
normal level) can be heard in the search mode, monitor
the sound and release the button when the required
position is located.
UX-A3 B/E/G/GI/EN
Direct access playback (using the remote
control)
@ Pressing any of the track number buttons will start play
from the beginning of the designated tune, without your
having to press the CD »/#I button. (This function
cannot be used during programmed play.)
0 a /CLEAR yc5
oa Se
eS = RereAL
= a
@ Press the B/CLEAR button to set to the CD mode.
@ If the PLAY button of the deck is pressed, press the
STOP/EJECT ( li/& ) button to set to the stop mode.
@ Designate the required tune using the track number
buttons.
®@ To designate tune numbers 1 to 10, press the track
number button corresponding to the tune (track)
number.
@ To designate tune number 11 or higher, press the
+10 button the required number of times, then the
track number button. (Example: To designate the
25th tune, press the +10 button twice, then press
track number button 5.)
* +10 button:
Each time this button is pressed, the number
increases by 10. First press this button to set the
10's digit, then press the track number button to set
the 1's digit.
e To skip to another tune during play
When the required track number button is pressed, the
display shows the designated track number and play
starts from the beginning of the designated tune.
(No. 1850) 11

JVC UX-A3 Specifications

General

Brand	JVC
Model	UX-A3
Category	Stereo System
Language	English