JVC UX-A3 User Manual

Example: To change to C-50
Press the +10 button four times, and within 10 seconds,
press the 10 button.
When the length of the tape is changed, some of the tunes
that were to be recorded on side A may be indicated as to
be recorded on side B or vice versa, according to the tape
length specified.
Depending on the tape length specified, some tunes may
not be recorded on the tape. Set the tape length (recording
time) so that the entire disc can be recorded.
@ When editing a disc with 16 to 99 tunes
CD editing can be used to record discs containing up to
99 tunes, however, the music calendar shows up to only
15 tunes.
As the 16th to 99th tunes will not appear in the program
chart display (the "OVER" indicator will light), be sure to
check the tunes you have recorded after completing
editing.
While recording, the track number of the tune being
played (and recorded) appears in the display for
confirmation.
® Set the DOLBY NR as required. The DOLBY NR
indicator lights.
Note:
The optimum sound quality will not be obtained if different
DOLBY NR switch settings are used during recording and
playback.
Synchronized recording with the CD player
@ In this system, the CD player starts playback when the
cassette deck enters the recording mode.
Operate in the order shown
oS
OS ese
— SEARCH—
1 2 3
Sees |
MEMORY CALL
INTRO as | oe
cs soem |
co} ics oe
EOIT SIDE AB
@ Load a disc and close the CD door.
@ Set to the CD mode.
® If the PLAY button of the deck is pressed, press the
STOP/EJECT (i@i/4&) button to set to the stop mode.
© Load a cassette with side A facing out. (Wind past the
leader tape before starting recording.)
@ When programmed playback is required, program the
required tunes using the remote control. (See page 27.)
e Select tunes with a total playing time which does not
exceed the tape length.
UX-A3 B/E/G/GI/EN
Note:
@ In CD edit recording, blanks of approx. 4 seconds will
automatically be left between tunes on the recorded
tape.
When automatic spacing between tunes is not
required ...
Perform the following:.
1. Press the [/ll PLAY/PAUSE button of the CD player
twice. The CD player enters the pause mode.
2. Press the O REC button with the PLAY button to start
recording.
Note:
e Depending on the disc used, blanks of a specified
length may be left between tunes.
e After use
Press the STOP/EJECT (™/4) button to release the CD
edit recording mode. (The CD edit recording mode is also
released when the CD door is opened.)
@ Set to the forward direction. (The » indicator lights.)
@ Select the required reverse mode( 2 or =).
@ Press the O REC button with the PLAY button;
synchronized recording will start.
(No. 1850) 17

JVC UX-A3 Specifications

General

Brand	JVC
Model	UX-A3
Category	Stereo System
Language	English