JVC UX-A3

SLEEP OPERATIONS
Use this when you want to fall asleep while
listening to a tape, radio broadcast or CD.
@ Set to the required source
Operations
Radio broadcast Press the TUNER/BAND button to set to the
tuner mode and tune to the required
frequency.
CD play Load a disc and press the BI button to play
the disc.
Load a cassette and press the PLAY button
to play back the tape.
Tape playback
@ Press the SLEEP button to set to the sleep time.
SLEEP
a SLEEP is shown in the display
~!
a et CH
=o 0
Source mode display (Releasing the sleep mode)
e Sleep times of 30, 60, 90 or 120 minutes can be set.
When you release the SLEEP button, the source is
displayed after 10 sec.
e@ The sleep operation will start and the power will be
switched off after the specified time. (Tuner & CD
modes)
The power will not be switched off at the specified time
| during tape operation and will switched off at the tape
| end. However, the power will not be switched off when
the reverse mode is set to" Ci> " or the deck is set to
the pause mode.
® Checking the sleep time
When the SLEEP button is pressed, the remaining sleep
time is displayed. If it is préssed again, a new sleep time
can be set. 7
© To cancel the sleep operation
Press the POWER button to switch the power off.
UX-A3 B/E/G/GI/EN
(No. 1850) 23