JVC UX-DM8 - Page 7

4
~ AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
For better FM reception
• Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75
Ω wire with coaxial type
connector (IEC or DIN45325).
Ÿ Speakers
• When connecting the speaker cords, match the polarity of
the speaker terminals: transparent to (+) and transparent
with black stripe to (–).
! To connect the power cord
• Disconnect the power cord before cleaning or moving the
System.
Extend it so that you can obtain the best
reception.
FM antenna (supplied)
AM loop antenna
(supplied)
FM outdoor antenna
(not supplied)
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
Left speaker
Transparent
Press and hold
Release
Insert
Transparent
with black
stripe
Transparent
Right speaker
Insert
Press and hold
Release
Transparent
with black
stripe
Power cord (supplied)
On the rear panel
To a wall outlet
UX-DM8[U].book Page 4 Monday, June 4, 2007 8:20 PM