JVC UX-M3R User Manual

– 18 –
Using Sleep Timer
With the sleep timer, you can fall asleep to music.
You can set the sleep timer using the remote control when the
unit is turned on.
How the sleep timer actually works
The unit automatically turns off after the specified time
length passes.
1 Press and hold SLEEP on
the remote control until the
desired time length appears
on the display.
The time length changes from 90 to 10 minutes in
10-minute steps.
2 Wait for a moment after specifying the time
length.
The SLEEP indicator lights up steadily on the display.
• Setting both the timer-off and sleep-off times causes the
unit to enter standby mode when the earlier one of them is
reached.
To change the shut-off time, repeat the procedure above.
To cancel the setting, press SLEEP so that the SLEEP
indicator goes off.
• The sleep timer is also canceled when you turn off the unit.
SLEEP
02_01_21_UXM3R_A_En.p65 02.1.21, 7:24 PM18

JVC UX-M3R Specifications

Amplifier Specifications

output power	24 W (12 W + 12 W) at 8 Ω (MAX.)
output power at THD	20 W (10 W + 10 W) at 8 Ω (10% THD)
audio output level	800 mV/32 Ω
speakers impedance	8 Ω - 16 Ω

Tuner Specifications

FM tuning range	87.50 MHz - 108.00 MHz
MW tuning range	522 kHz - 1 629 kHz

CD Player Specifications

dynamic range	60 dB
signal-to-noise ratio	60 dB
wow and flutter	Unmeasurable

Cassette Deck Specifications

frequency response for normal tape	100 Hz - 10 000 Hz
wow and flutter	0.35% (WRMS)

General Specifications

power requirement	AC 240 V, 50 Hz
power consumption (operation mode)	30 W
power consumption (standby mode)	1.5 W
dimensions	160 mm × 269.5 mm × 300 mm
mass	4.3 kg

Speaker Specifications

speaker unit (woofer)	10.2 cm cone × 1
speaker unit (tweeter)	5.1 cm cone × 1
impedance	8 Ω
dimensions	160 mm × 269.5 mm × 192 mm
mass	2 kg/each