JVC XV-M565BK Service Manual

XV-M565BK/M567GD
1-11
Disconnect the card wire from connector CN101 on
the traverse mechanism control board on the bottom
of the DVD changer mechanism assembly.
Remove the screw L attaching the traverse
mechanism control board. Release the three parts e,
f and g and remove the traverse mechanism control
board.
Disconnect the card wire from connector CN102 on
the traverse mechanism control board.
1.
2.
3.
Prior to performing the following procedure, remove
the top cover and the DVD changer mechanism
assembly.
Removing the traverse mechanism
control board (See Fig.18)
The DVD tray can not be ejected when the traverse
mechanism is up.
When the DVD is set or the traverse
mechanism is up.
The motor pulley and the belt can be seen on the
front side of the changer. Turn the motor pulley
clockwise until the belt stops.
Pull the tray lock lever on the left side of the changer
and draw the DVD tray.
Draw the DVD tray 1 to 3 as above.
1.
2.
3.
Bringing down the traverse mechanism
as shown in the Fig.20
< DVD Changer Mechanism Assembly >
Ejecting the DVD (See Fig.19 and 20)
DVD traverse
mechanism
control board
CN101
CN102
L
Part e
Part f
Part g
DVD changer mechanism assembly
Fig.18
Fig.19
Fig.20
Motor pulley
Belt
Draw the DVD tray.
Tray lock lever
Tray stopper
Traverse mechanism
As the motor pulley is
turned, the traverse
mechanism lowers.

JVC XV-M565BK Specifications

General

Brand	JVC
Model	XV-M565BK
Category	DVD Player
Language	English