XV-M565BK/M567GD
1-8
Prior to performing the following procedure, remove
the top cover.
Disconnect the harness from connector CN971 and
CN972 on the regulator board (The harness is
extending from the front panel assembly).
Disconnect the 9pin harness from connector CN961
on the power supply board (The harness is
extending from the DVD changer mechanism
assembly).
Disconnect the harness from connector CN951 and
CN952 on the power supply board (The harness is
extending from the system control board).
Remove the screw D attaching the AC jack on the
rear panel.
Remove the two screws G attaching the power
supply board and detach the power supply board.
1.
2.
3.
4.
5.
Removing the Power supply board
(See Fig.9 and 10)
G
G
Power supply board
Front panel assembly
Rear panel
CN961
CN951
CN952
CN971
CN972
Shield case
Fig.9
Fig.10
D
Rear panel
To Next Page
Loading...
Need help?
General
