21
5
Now leave the cleaning agent 2 minu-
tes to activate. Start the cleaning process
by pressing the "Large cup" button (mi-
nimum quantity 100 - 200 ml). The clea-
ning fluid may turn slightly green during
the cleaning process.
6
Now open the lever, activate capsule
ejection, close the lever and empty the
collecting container. Replace the emp-
ty collecting container under the spout
again.
7
Now press the "Large cup" button
again to rinse the appliance out with fresh
water (do not insert a capsule!). Repeat
this process until the water dispensing
from the spout is clear.
8
To complete, remove the collecting
container and the water tank, empty
them and clean in hot water. Then fill the
water tank with fresh water and replace it
in the appliance with the drip tray.
NOTE Exact water quantities
dispensed in steps 4 and 5
will depend on the machines
current programmed cup capacity. To
meet minimum volumes in step 4 and
5 reset factory settings (page 15) prior
to cleaning process.
WARNING Very hot water –
scalding hazard.
PROHIBITED
Do not drink the cleaning
fluid – health hazard.
6
4
5
7
To Next Page
Loading...
