8-2.
Mount the lock from the outside of the door.
1) Insert the tailpiece Y into the horizontal
cutout of the latch assembly and the
tail piece X into the
3
⁄4" (19 mm) hole,
figure 8-1.
2) Hold the exterior lock assembly (pg.7, A)
firmly against the door. Try the factory-set
combination. Press buttons #2 and #4
together, release, press button #3, and
release. A distinctive click must be felt to
indicate that the button has been correctly
depressed. Turn the outside thumbturn to
the right (clockwise) to the stop position
(the lach should be fully retracted).
If not, turn the thumbturn to the left
(counter clockwise) to the stop position
and repeat Step 2.
3) While holding the lock firmly against
the outside surface of the door with one
hand, use the other to mount the inside
thumbturn assembly (pg.7, D) to the interior
side of the door with two thru-bolts finger
tight,
figure 8-2. Make sure that tailpiece
Y is engaged into the horizontal cutout of the
inside thumbturn assembly.
4) Insert tailpiece X into the horizontal slot
of the combination change assembly, (pg.7, E).
It may be necessary to use a screwdriver to
align tailpiece
X with the combination
change assembly, figures 8-2 & 8-3. Once
aligned, secure with two thru-bolts, but do
not tighten, figure 8-4.
Note: The inside thumbturn is shown
in a vertical position to show the two
thrubolts. It may be assembled either
vertically or horizontally.
Installing the Lock
- For 1
3
⁄8" - 1
3
⁄4" (33 - 44mm) thick doors,
use the 2
3
⁄8" (45mm) thru bolts.
- For 2"- 2
1
⁄4" (51- 57mm) thick doors,
use the 3" (76mm) thru bolts.
To Next Page
Loading...
