12
10-1.
10
11
Installing the Strike
1) Mark the vertical and horizontal center
lines of the strike on the door frame by
using the center line of the bolt. Make sure
the vertical and horizontal center lines are
well aligned with the latch bolt center lines.
2) Where the center lines meet, drill a
1
⁄8" (2.5 mm) diameter by
5
⁄8" (16 mm)
deep hole to guarantee that the latch
will be completely extended in the door jamb,
figure 10-1.
3) Mortise (chisel out) the marked area to
1
⁄16" (1.5 mm) deep so that the strike will be
flush with the door frame.
4) Secure the strike, (PG.7, F) with the two
screws provided, (PG.7, H).
5) Close the door to ensure proper alignment
of the latch with the strike plate hole.
Setting a
New Combination
IMPORTANT: The following steps must
be performed while the door is open.
The factory-set code is 2 and 4 pressed
simultaneously, followed by 3.This code
should be changed as soon as the lock
is installed.
1) Turn the outside thumbturn to the left
(counterclockwise) to the stop position and
return it to the right (clockwise) slowly to
the horizontal position. This will clear any
random buttons previously depressed.
2) Enter the existing code.
3) Insert a Phillips-head screwdriver into the
center of the combination change sleeve.
To Next Page
Loading...
