Kaba Peaks Preferred

Section 5 - 7
Cylinder Installation Guide
Division of Ingersoll Rand
• “FALCON” appears on the latch face.
.
TOOLS:
• Spanner wrench is required for grade 1.
•
1
/16 " pin punch for depressing retainer.
hole in
edge of rose
rose
Amityville, New York
• “MARKS” appears on the latch face.
• Grade 1 and 2 cylindrical locks can be prepped for small format interchangeable core.
• Current Marks deadbolts accept only 6-pin small format interchangeable core.
knob
Falcon Lock Co.
Marks USA
• 8400-xx-1095 is identical to 8400-xx-1099 and 3400-xx-1095 is identical to 3400-xx-1099, except for the
small diameter plug face required for Falcon dead locks and old style X series unit locks.
Falcon LY series X series RU and X series S series D series
grade 1 grade 1 grade 1 unit lock grade 2 tubular
levers knobs preassembled knobs deadlocks/latches
retrofit type KDH KDH KDH KDH
Peaks Preferred 8400-xx-1099 8400-xx-1099 8400-xx-1099 8400-xx-1099 8400-xx-1095
Peaks Classic 3400-xx-1099 3400-xx-1099 3400-xx-1099 3400-xx-1099 3400-xx-1095
*with original Marks tailpieces
TOOLS:
• Marks spanner wrench (engages entire rose) is
required to install lockset, but not to change
cylinders.
Marks 195/295 180 170/270 110/120 130 Deadlocks
grade 1 grade 1 grade 2 grade 2
levers knobs levers knobs
retrofit type KDH KDH KDH KDH
Peaks Preferred 8400-xx-1099* 8400-xx-1099* 8400-xx-1099* 8400-xx-1099* 8400-xx-1099*
Peaks Classic 3400-xx1099* 3400-xx1099* 3400-xx1099* 3400-xx1099* 3400-xx1099*