KAL-FIRE Fairo 60 - Trouble Shooting

8. Trouble shooting
52
F6 or
No
communication
between
receiver and
transmitter.
Is there
electricity?
Is receiver
reachable?
Is the red light
flashing on the
receiver?
N
Y
Y
N
Receiver
faulty.
Try to start the Fairo manually by pressing the
button next to the flashing lamp. Does this work?
Y
N
N
Do you get the same
error message when the
the remote control is placed
near the receiver?
The signal is probably
blocked.
N
Check if the ignition cable is not running over the
receiver. Is the ignition cable free?
Y
Ensure this is free.
N
1. Press Menu-key for 10 sec.
2. Select option BND in the special menu by
pressing the Menu-key briefly several times.
3. Remove power from the appliance for 5
seconds, then apply power again.
4. Make connection by pressing both arrow keys
simultaneously.
5. Re-start the appliance.
6. Has the error message disappeared?
Try to reconnect the
receiver and
transmitter.
Y
Check if the convection is working correctly.
Supply and exhaust of convection air must end up
in the same pressure area-.
Automatic burner
Faulty.
Receiver faulty.
Contact your dealer.
F2: technical box
has become too
warm.
Fairo is given a start
command, but fails to start
or does not jump to error.
Check if the Fairo
is not
set to timer or
thermostat mode.
Fairo goes on and off
randomly.
N