Sensor is not functioning:
1 Check sensors in service mode (first press “Start Boxing” [when
checking Boxer] or press “Start Kicking” [when checking
Kicker/Soccer] and use switch #1 on the main board (S1) and
manipulate button SW1 go to mode P07), if punching bag
(while checking Boxer) or kicker arm (while checking
Kicker/Soccer) is moving UP/DOWN and on the main board
(depending on bag/arm position) HI – LO shows this would
indicate that sensor is working.
2 Check if sensor cable is firmly connected to the main board.
3 Check all wires to/from the sensor.
Halogen lights are not functioning:
1 Check power supply cable connection.
2 Check power supply wire integrity.
3 Check connector plug for loose bulb.
4 Check if halogen is not burned by swapping it with a new one
(12V 20W).
Button START or GAME is not functioning:
1 Check for main board cable connection.
2 Check switch/button cable connection.
Computer power supply is not functioning:
1 Check if power supply cable is plugged in securely.
To Next Page
Loading...
Need help?
General
