P07
THIS FUNCTION IS USED FOR TESTING OF THE SENSOR
(DIAGNOSTIC FUNCTION).
WHEN PUNCHING BAG IS IN THE VERTICAL POSITION - THE
DISPLAY SHOWS - "LO", WHEN PUNCHING BAG IS IN THE
HORIZONTAL POSITION - DISPLAY SHOWS "HI”.
P08
YOU CAN SET THE BEST SCORE WHICH WILL BE ON THE
DISPLAY FOR POWER MODE ONLY. PLAYERS WILL NEVER
BE ABLE TO RECEIVE A HIGHER SCORE (WHICH MUST BE
SET BETWEEN 900 AND 990). YOU CAN ADJUST THIS VALUE
BY USING “START BOXING” (UP) AND “SELECT GAME”
(DOWN) BUTTONS. AFTER YOU SET THE DESIRED
UNATTAINABLE POWER HIGHEST SCORE YOU MUST TURN
SWITCH # 5 TO “ON” POSITION.
IMPORTANT: AFTER YOU SET THE RECORD AND PUT
SWITCH #5 TO “ON” POSITION YOU MUST TURN OFF THE
MACHINE FOR 5 SECONDS.
P09
THIS FUNCTION IS USED FOR DIFFERENT SETTINGS OF THE
COIN ACCEPTOR, FOR EXAMPLE: 0-USA, 1-CANADA.
NOTE: IF THE BILL ACCEPTOR IS SET 4 PULSES FOR A 1$,
SET P09 TO 12 (in case of the older software to 5).
P10
PARAMETER USED BY FACTORY. DEFAULT SETTING IS 0.
P11
HOPPER OUTPUT DEVICE SETTING
0 - OFF,
1 - TICKET DISPENSER,
2 - BALL DISPENSER,
3 - POWER ALWAYS ON (USED FOR THERMAL
PRINTERS).
NOTE: IN ORDER TO MANUALLY FEED THE TICKET
DISPENSER PRESS AND HOLD IN THE SAME TIME
SWITCH SW1 AND SW2.
DEFAULT SETTING IS 3.
To Next Page
Loading...
Need help?
General
