28
6-1 Alarm
The procedure for setting the alarm is shown below.
Power Up
<MENU>
1.MEASURE MODE
2.DATA PROCESSING
3.OPTIONS
< OPTION >
1. ALARM 4. HOTKEY
2. UNITS 5. AUTOST.
3. UTILITIES
Press ENTER key
<ALARM>
1. 0.3um 1.00E+5
2. 0.5um 1.00E+4
3. 5.0um 1.00E+3
< OPTION >
1. ALARM 4. HOTKEY
2. UNITS 5. AUTOST.
3. UTILITIES
Alarm level can be set for each particle size as a
cleanliness criterion. When the set alarm level is
crossed, the reading will flash during a
measurement. Then, you will hear two beeps after
the measurement is complete.
The alarm level setting can only be made for
the “CNT” unit.
Press ENTER key
Press ENTER key
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
