Kanomax 3887 - Changing Measurement Unit

29
6-2 Changing Measurement Unit
The procedure for changing the measurement unit is shown below.
Power Up
<MENU>
1.MEASURE MODE
2.DATA PROCESSING
3.OPTIONS
< OPTION >
1. ALARM 4. HOTKEY
2. UNITS 5. AUTOST.
3. UTILITIES
Press ENTER key
<UNITS>
SETUP
1.PTCL CNT
Press PREV key
< OPTION >
1. ALARM 4. HOTKEY
2. UNITS 5. AUTOST.
3. UTILITIES
Change the unit by using the ▲▼ key.
The unit changes in the following sequence.
▲: CNT → /cf → /m
3
→ CNT
▼: /m
3
→ /cf → CNT → /m
3
Press ENTER key
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com