12
Connecting Bluetooth
®
REN features Bluetooth
®
5.3 with the AAC codec and can be paired with many devices for wireless
audio playback from your phone or tablet. Pairing is easy.
1. Press the Bluetooth
®
button on REN’s remote to select BT as the input source. You can also
cycle through inputs by pressing the control knob on the front of REN. REN will attempt to
reconnect to the last connected device but is also available for new devices to connect. You can
also enter pairing mode manually by pressing the Bluetooth
®
Reset button ( ) on the remote
(see diagram of Remote Control on Pg. 6 – button #15).
2. Enable your Bluetooth
®
device to search for a new device to pair with. Select ‘REN by Kanto’
from the list of Bluetooth
®
devices available for pairing.
3. If pairing is successful, the LED will remain solid. You will not need to pair the same Bluetooth
®
device again – ‘REN by Kanto’ will remain on your device list until you remove it from the list.
4. If the device does not pair with REN, press the Bluetooth
®
Reset button ( ) on the remote
or turn o Bluetooth
®
on your device and turn it back on again, then repeat Steps 1 to 3.
Alternatively, you can turn the speaker’s Power Switch to the OFF position, then back to ON.
Bluetooth
®
Operation
1. We recommend keeping a maximum distance of less than 10 meters (33 ft) between the
speaker and your device. The best signal delity is within this range.
2. You can stream audio from your device to the speaker using either the player control buttons of
your device or the control buttons of the remote control (see diagram of Remote Control on Pg.
6 of this manual – buttons #18, #19, and #20).
3. Take note of the following behavior and functionality during Bluetooth
®
operation. When you
are successfully connected, the LED will be lit solid, and your device will show as connected to
‘REN by Kanto’.
4. The REN remote control features a Bluetooth
®
Reset button to quickly disconnect a paired
device and allow a second device to pair with the speaker. Press Bluetooth
®
Reset button ( )
to disconnect a paired device if necessary.
5. Follow the pairing instructions to pair another device.
6. The same behavior and functionality apply to the second device.
To Next Page
Loading...
