Chapter 5 - Personal Packet Mailbox
34
1. Community PBBS initiates a connect to your station using your personal mailbox callsign:
C WA5RGU-1
2. Your station will respond with the mailbox sign on message:
WELCOME TO (your callsign) PERSONAL BULLETIN BOARD
ENTER COMMAND: Bye, Kill#, List, Read#, Send(callsign)
>
3. The Community PBBS should send one of the following:
S callsign
SB callsign
SP callsign
ST callsign
S callsign < callsign
SB callsign < callsign
SP callsign < callsign
ST callsign < callsign
S callsign @ callsign < callsign
SB callsign @ callsign < callsign
SP callsign @ callsign < callsign
ST callsign @ callsign < callsign
4. Your personal mailbox then responds with:
ENTER MESSAGE - END WITH CTRL-Z OR /EX
The community PBBS can now autoforward all messages destined for your station.
To Next Page
Loading...
