Chapter 7 - Commands and Messages
71
COMMAND SUMMARY
COMMAND FUNCTION
8bitconv Strip 8
th
data bit?
ABaud Sets serial port baud rate
ALlias Use MYAlias for digipeating?
AMtor AMTOR standby mode or Mode A Master
ASCBaud Sets ASCII baud rate
Ascii Places unit in ASCII Mode
AUtocr Sets interval for automatic transmission of CR
AUTOLf Send LF to terminal after CR?
AUTOStrt Enables AUTOstart RTTY/ASCII/FEC operation
AX2512v2 Version 1 or version 2 protocol?
AXDelay Add time to TXDelay for repeaters?
AXHang Use repeater hang time?
Beacon Beacon timing every/after n × 10 seconds
BKondel BS-space-BS or / for delete?
BText Text used when beaconing
BUDCalls List up to 10 callsigns to monitor
BUdlist Monitor BUDCalls?
CALibrat Check VHF equalization
CAnline CTRL-X cancels a line
CANPac CTRL-Y cancels a packet or terminal output buffer
CCitt Use European tones in non-packet modes?
CHeck Packet activity timeout in 10-sec intervals
CMdtime Escape transparent mode
CMSg Send CTEXT message on connect?
COMmand CTRL-C used for commands or getting into command mode
CONMode Convers or transparent when you connect?
Connect Immediate command for packet connect or status
CONOK Master switch to allow incoming connections
CONVers Enter convers mode in Packet
CPactime Use Pactime in convers mode?
CR Add CR to packets in convers mode?
CRAdd Adds an extra CR to all CRs sent in non-packet modes
CRLfsup Inhibits printing of extra CR/LFs
CStamp Time stamp printed on connect and disconnect
CText Special message to send if someone connects to you
CW Places unit in CW mode
CWBand Sets bandwidth of CW filter
CWSpeed Sets default Morse speed
CWTone Sets center frequency of CW filter
DAytime Set calendar/clock
DAYTWeak Fine tune adjust for clock
DAYUsa US or European format for date
DBldisc # D's needed after unsuccessful connect
DElete Backspace character
DIDdle Diddle characters during RTTY/ASCII transmit?
DIGipeat Allow digipeating?
Disconnect Disconnect current packet stream
DISPlay Displays parameters or classes of parameters
DWait Digipeaters do not have to wait
Echo See what you are typing?
To Next Page
Loading...
