Chapter 7 - Commands and Messages
48
DISCONNECT in progress
A disconnect has already been issued. Connects are not legal in this state and a second discon-
nect will cause a "retry count exceeded" condition.
REJ frame sent
A reject packet has been sent in response to a packet received out of proper sequence.
Waiting acknowledgment
The time specified by
FRack
has been exceeded without a proper acknowledgment for a packet
sent. A retry sequence is in progress.
Device busy
The KAM is not able to accept further data packets from the radio for the time being. An RNR
(Receiver Not Ready) has been sent.
*** FRMR sent
Frame reject packet has been sent due to a detected error in protocol. Three bytes (6 hexadec-
imal characters) are displayed to assist in determining the reason for the reject.
*** FRMR received
A frame reject packet has been received for an unknown reason. The information field of this
packet will display in hexadecimal value. This display may be useful in determining why the receiv-
ing station rejected your packet.
PBBS NOT ENABLED
This is the KAM response to a
PBList
,
PBRead
,
PBKill
or
PBSend
command if the PBBS has not
been enabled by allocation of RAM.
PBBS BUSY
This is the KAM response to a connect request when it is already connected to.
To Next Page
Loading...
