Chapter 7 - Commands and Messages
59
MRPt ON|OFF default OFF/OFF
This command affects the way monitored packets are displayed. If OFF, only the originating
station and the destination are displayed for monitored packets. If ON, the entire digipeat list is
displayed for monitored packets, and the station that relayed the packet is indicated with an aste-
risk.
MStamp ON|OFF default OFF
This command enables time stamping of monitored packets. The date and time information is
then available for use for automatic logging of packet activity or other computer applications. The
date and time are set initially by the
DAytime
command, and the date format is determined by the
DAYUsa
command.
MYAlias
xxxxxx-n
This command allows the entry of an alternate identifier to be used for packet digipeat opera-
tions. For example; you may enter LAW-3 as the
MYAlias
, which would be easier to remember for
stations wishing to digipeat through a station in Lawrence, enroute to a station more distant. The
HId
command will identify normally with the
MYcall
specified, thus allowing an alternate identifier
(
MYAlias
) to be established for digipeater address only.
MYPbbs
xxxxxx-n
Enter up to six characters which will be used as the operating address for your Personal Packet
Mailbox. If no entry is made, the mailbox will use your callsign entered sign-on. SSID suffixes may
be used with this command.
MYcall
xxxxxx-n
This command tells the KAM what its callsign is. This callsign will be placed in the FROM ad-
dress field for all packets originated by it, and it will respond to frames with this call sign in the TO
or digipeat fields as appropriate. This callsign is also used in autostart ASCII/RTTY operation. The
callsign in the default parameter list is blanks and must be changed for proper operation of the
protocols. The default for the extension is zero, but may be any number from 0 to 15. The exten-
sion is not used in ASCII/RTTY autostart operation.
MYGate
xxxxxx-n
This command tells the KAM what its gateway callsign is. Another user may digipeat from one
radio port to the other if
MYGate
is specified in the Packet digipeat field and Gateway is ON.
MYSelcal
xxxx
This command is used to enter the selcall for SELFEC and ARQ. The convention used for AM-
TOR selcalls is to use the first and last three letters of your callsign as your selcall. If your callsign
has only three letters, use the first letter twice. For example, use WWXI for W0XI or use WRGU for
WA5RGU.
NEwmode ON|OFF default OFF
When ON, the KAM will return to Command Mode if the other station disconnects. If multicon-
nected, the unit will return to Command Mode only if the station disconnecting is on the current
stream.
NOmode ON|OFF default OFF
When ON, the KAM stays in Command Mode after connecting to another station; that is, it
does not immediately change to Convers or Transparent Mode.
NUcr
n
default 0
This command determines the number of nulls sent to the computer or terminal after a CR.
This command enables a transmission delay following any CR sent to the terminal. This is useful
for some hardcopy terminals.
n
= 0 to 31.
To Next Page
Loading...
