EasyManua.ls Logo

Kantronics KAM - Page 73

Default Icon
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 7 - Commands and Messages
73
PBKill Delete a message from the Personal Mailbox
PBList Lists message headers and number of messages
PBMon Monitors messages sent to your mailbox
PBRead Read a message in Mailbox
PBSend Put a message in Mailbox
PErm Makes parameter values permanent in EEPROM
PId Accept I frames with different PIDs?
PMode Permanent power-up mode
RBaud Sets BAUDOT/RTTY speed
REconnect Use to change paths
REDisplay CTRL-R will redisplay the keyboard buffer
RESet Soft reset, unpermed parameters retained
RESPtime Delay before acknowledging in 100 ms intervals
RETry Max # of retrys
RIng Bell characters when ***connected to?
Rtty Places unit in BAUDOT/RTTY mode
SCreenln Terminal screen length
SEndpac CR will cause packet to be formed
SHift Sets RTTY/ASCII/AMTOR shift
SLottime Determines time between retries
SPace Sets space tone frequency for modem shift
STARt CTRL-Q restarts unit printing
STATShrt Short status displayed
Status Display status of all streams
STOp CTRL-S stops unit from printing
STREAMCa Callsign displayed after stream ID?
STREAMDb Print, stream switch character twice?
STREAMEv Display stream ID when?
STReamsw Character to indicate switching streams
SUPCalls Up to 10 callsigns to ignore
SUplist Ignore SUPCalls?
TRACe Display all received packets in hex
Trans Immediate Trans mode
TRFlow Software flow control in transparent mode?
TXDAmtor Transmitter turn on for AMTOR
TXdelay Transmitter turn on delay for Packet
TXFlow Flow control in transparent mode
Unproto Path for beacons and UIs
USers Determines the # of streams which others can connect
USOs Unshift on space in RTTY
Xflow Hardware/Software flow control
XMitecho Echo characters as transmitted?
XOff CTRL-S stops terminal from sending
XON CTRL-Q restarts terminal
CTRL-C R Return to receive
CTRL-C E Return to receive when transmit buffer empty
CTRL-C T Transmit
CTRL-C I Toggle inversion
CTRL-C S Select shift
CTRL-C X Return to command mode
CTRL-C n Change speeds
CTRL-L Send RTTY letter shift character
CTRL-N Send RTTY figure shift character

Other manuals for Kantronics KAM

Related product manuals