KAPSCH T600 - Page 3

To Next Page

To Previous Page

T600 Tag Tester

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence

and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for

manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: UM 360420-835 REV F, T600 OPERATOR AND MAINTENANCE MANUAL.DOCX

Kapsch TrafficCom

T600 Tag Tester

Operator and Maintenance Manual

DOCUMENT: UM 360420-835

REVISION: F

DATE: 28 Mar 2022

Kapsch TrafficCom Canada Inc.

6020 AMBLER DRIVE 2855 PREMIERE PARKWAY, SUITE F

MISSISSAUGA, ON L4W 2P1 DULUTH, GA 30097

TEL: (905) 624-3020 TEL: (678) 473-6400

FAX: (905) 625-6197 FAX: (678) 473-9003

Main Page

Table of Contents9
About this Manual13
Warnings and Cautions13
Warnings13
Cautions14
Operating Instructions15
Overview17
Introduction17
T600 System Components17
Figure 2-1: T600 Tag Tester System Components17
T600 Tag Tester Unit (TTU)18
TTU Antenna18
TTU OBU Cradle18
Figure 2-2: Tag Tester Unit (TTU) - Front View18
T600 Software19
Figure 2-3: Tag Tester Unit (TTU) - Rear View19
Figure 2-4: Tag Pass Message20
Figure 2-5: Tag Failure Message20
How the T600 Tag Tester Works21
The Test Results21
Margin Results21
Correct Tag Data21
T600 Tag Tester Communication Functional Blocks22
Figure 2-6: T600 Tag Tester Communication Block Diagram22
Operating Procedures23
Starting up the T600 Tag Tester23
Testing a Tag23
Entering the OBU Bar Code Number24
Figure 3-1: the Transponder Barcode Label Window25
Understanding the T600 Test Data26
Configuring Log Files27
Command and Controls29
Maintenance Instructions35
Theory of Operations37
Calibration37
The Write Tests37
The Burst Tests37
Installation38
System Requirements for Customer-Supplied Computer38
Installing the T600 Hardware38
T600 Connections38
Optional Hand-Held Bar Code Scanner Connections38
Installing the T600 Software39
Installing the Calibration Files40
Installing /Upgrading the Agency Mapping File41
Configuring the T600 Tag Tester Communication Settings41
Configuring Communications between the TTU and the Computer41
Configuring Communications between the Internal Bar Code Scanner and the Computer41
Agency Mapping File Configuration for Tag Types42
How to Identify Interior OBU (G4E) from the Older Model FPT (G3B)43
How to Identify Exterior OBU (FME) from the Older Model LPT43
Examples44
Troubleshooting and Testing45
Troubleshooting Tree: Communications Error - Check Serial Connection46
Troubleshooting Tree: Test Fail - Tag Position Failure (IR Beam)47
Troubleshooting Tree: Tag Fail - Bar Code Mismatch with Tag Contents48
The Internal TTU Bar Code Scanner Cannot Read the OBU Bar Code49
The TTU Cannot Read the OBU Bar Code or the OBU Tag Data49
Resolving a Missing Calibration File Error49
TTU Functional Check50
Sending Log Files to Kapsch Trafficcom Canada Inc50
Figure 6-1: the Functional Check Requirement Message50
Maintenance Procedures51
Preventive Maintenance Procedures and Scheduling51
Appendix52
G4 Obu52
Flat Pack Transponder (FPT)52
Figure 8-1: G4 OBU52
Figure 8-2: Flat Pack Transponder (FPT)52
Front Mount Exterior (FME) OBU53
Roof-Mount FPT53
Figure 8-3: Front Mount Exterior (FME) OBU53
Figure 8-4: Roof Mount FTP53
Figure 8-5: Front Mount OBU - Motorcycle54
Figure 8-6: High Occupancy Toll (HOT) OBU54
Reference Documents55
Kapsch Trafficcom Canada Inc. Documents55
Other Commercial Documents55
Accessing Documentation56
Acronyms56

KAPSCH T600 - Page 3

Table of Contents