T600 Tag Tester
DOC#: UM 360420-835 REVISION F Page 40 of 55
© Kapsch TrafficCom Canada Inc. 2022
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence
and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for
manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: UM 360420-835 REV F, T600 OPERATOR AND MAINTENANCE MANUAL.DOCX 03/28/2022 3:02
ATTENTION: The following sections:
• Agency mapping file configuration for tag types
• How to identify interior OBU (G4E) from the older model FPT (G3B)
• How to identify exterior OBU (FME) from the older model LPT
apply to Kapsch service personnel.
Agency mapping file configuration for tag types
The new model Interior OBU (G4E) is used to replace the old model FPT (G3B) which shares the same type# 0
The new model Exterior OBU (FME) is used to replace the old model LPT which shares the same type# 2.
To identify the model of a tag, the tag serial number is used.
The serial number ranges for the new models are specified in the agency mapping file T600Cfg.xml. If a tag serial
number is not specified, the default is the old model.
The following table lists the Tag types and their descriptions.
Table 5-1: Tag Types Descriptions
To Next Page
Loading...