MACRO REMOTE
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits
for a class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
* The machine operator must follow OSHA and other applicable
standards when operating the equipment. Do not use high power
radio devices in close proximity of this product.
This equipment has been certified to comply with the limits for a class
B computing device, pursuant to FCC Rules. In order to maintain
compliance with FCC regulations, shielded cables must be used with
this equipment. Operation with non-approved equipment or unshielded
cables is likely to result in interference to radio and TV reception. The
user is cautioned that changes and modifications made to the
equipment without the approval of manufacturer could void the user's
authority to operate this equipment.
To Previous Page
Loading...
