KAR-TECH MACRO - Before Applying Power

MACRO REMOTE
9
performance. Antenna extension
cables are available from Kar-
Tech to aid in this, if needed.
The main power to the receiver
should be connected through a
switched, fused line capable of a
minimum of 20 amps. For best
results, connect power (+) to
the receiver via an auxiliary
terminal of the ignition switch,
PTO switch, or ignition relay. Be
sure that the ground (-) is
connected securely to the
battery ground with a star
washer which digs into the base
metal to insure good contact
Connect CAN HIGH of radio
receiver to CAN HIGH of can
receiver and connect CAN LOW
of radio receiver to CAN LOW of
can receiver for proper
operation.
All connections must be properly
insulated to protect against
shorts.
Seal all connections with a non-
conductive silicone grease to
prevent corrosion.
BEFORE APPLYING
POWER!
 Check power and ground for
proper polarity.
 Check the wiring harness for
possible shorts before
connecting to output devices
(i.e., valves and relays) by
checking each mating pin
terminal.
 Verify that the transmitter
battery is fully charged.
 Read the rest of this manual