9. Plug the power cord of the high pressure washer into the electrical outlet.
①
②
8. Screw on the water inlet connector and inlet hose
Screw the water inlet connector (13) into the water inlet connection (11). Subsequent-
ly, insert the 1/2 quick connect (18) into the water connector (13) and then connect the
hose (without water supply) to the quick connect (18). Connect the other end of the
hose to a residential water supply point.
WARNING: The equipment is DESIGNED to be used with water with a temperature
above 0°C and a maximum of 40°C.
WARNING: The garden hose must not be damaged or leaking; It cannot have a
diameter less than 1/2 inch and its length must not exceed 8 meters.
SETING UP
WARNING ‒ DANGER!
During operation, the equipment must be placed on a firm and stable
surface.
WARNING: The high pressure hose must not be coiled.
Starting up
1. Turn on the water supply. Press the trigger for approximately 1 minute until low
pressure water flows out to remove air from the unit.
WARNING: This unit is designed to be used with cold water only! Do not use hot water
with this high pressure washer!
35
To Next Page
Loading...
