Kärcher SC 1.020 Original Instructions

English 9
It is recommended to sweep or vacuum the floor
prior to using the steam cleaner. This way, the
floor is already cleared of dirt/loose particles pri-
or to the wet cleaning.
Prior to treatment with the steam cleaner, always
check the reaction of the textiles in an inconspic-
uous location: Steam at first, then let dry and
then check for colour or shape changes.
When cleaning painted or plastic-coated surfac-
es, as found on kitchen and living room furniture,
doors, parquet; wax, furniture polish, plastic sur-
faces or paint can come loose or stains can be
created. When cleaning these surfaces, briefly
steam a cloth and wipe the surfaces with it.
CAUTION
Never direct the steam jet at glued edges as the
edge band may loosen. Do not use the steam
cleaner on unsealed wooden or parquet floors.
In case of low outside temperatures, especially
in the winter, warm up the window pane by slight-
ly steaming the entire glass surface. This will
prevent tensions on the surface which might lead
to glass breakage.
Then clean the window surface with the hand
nozzle and attachment. Use a squeegee to re-
move the water or wipe the surfaces dry.
CAUTION
Do not direct steam onto the sealed locations of
the window frame to prevent damage.
You can use the steam gun without any addition-
al accessories, e.g.:
– to remove odours and wrinkles from hanging
clothes by steaming them at a distance of 10
to 20 cm.
– to remove dust from plants. Here, keep a dis-
tance of 20-40 cm.
– for moist dusting, by briefly steaming the
cloth and wiping the furniture with it.
The closer this nozzle is to the contaminated ar-
ea, the higher the cleaning effect, as the temper-
ature and the steam are highest at the nozzle
output. Especially suited for cleaning difficult ac-
cess locations, joints, fittings, drains, sinks, toi-
lets, blinds and heaters. Heavy lime scale can be
drenched in vinegar prior to steam-cleaning. Let
the vinegar penetrate for about 5 minutes.
The round brush can be installed onto the detail
nozzle as an accessory. Attached brushes can
therefore be used to remove heavy soiling.
CAUTION
Not suited for the cleaning of sensitive surfaces.
 Illustration
Attach the round brush to the detail nozzle.
Pull the terry cloth cover over the hand nozzle.
Especially well-suited for small washable areas,
shower stalls and mirrors.
Suited for all washable walls and floor coverings,
e.g. stone floors, tiles and PVC floors. Work
slowly on very dirty surfaces to allow the steam
to act on the dirt for a longer period of time.
Note: Detergent residue or care emulsions that
are still present on the surfaces to be cleaned,
can lead to smears when steam cleaned. How-
ever, these will disappear with repeated cleaning
procedures.
 Illustration
Attach the floor cloth to the floor nozzle.
1 Fold the floor cloth the long way and place
the floor nozzle on top of it.
2 Open holding clamps.
3 Place the cloth ends into the openings.
4 Close the holding clamps.
CAUTION
Do not insert fingers between the clamps.
 Illustration
During work breaks, hook the floor nozzle
into the parking holder.
How to Use the Accessories
Important application instructions
Cleaning floor surfaces
Refreshing textiles
Cleaning of Coated or Lacquered Surfaces
Cleaning of Glass
Steam gun
Detail nozzle
Round brush
Hand nozzle
Floor nozzle
Parking the floor nozzle

Kärcher SC 1.020 Specifications

General

Type	Cylinder steam cleaner
Capacity	1 L
Cord length	4 m
Product color	Black, Yellow
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Ready time	8 min
Steam pressure	3.2 bar
Hard floor brush	Yes

Weight and Dimensions

Depth	380 mm
Width	254 mm
Height	260 mm
Weight	3000 g