Kärcher SP 2 Flat User Manual (English)

Questions and Answers:

H
Heather ScottJul 29, 2025
What to do if my Kärcher SP 2 Flat Pressure Washer pump does not run?
- J
  justinnortonJul 29, 2025
  If your Kärcher Pressure Washer pump isn't running or stops suddenly, there might be a few reasons. First, ensure the power supply hasn't been interrupted by checking fuses and electrical connections. Overheating can also cause the thermal protection switch to turn off the pump; if this happens, unplug the pump, let it cool down, and clean the suction area, making sure to prevent dry running. Debris in the suction area can also cause this, so unplug the pump and clean the suction area. Finally, check the float switch position, as it might be stopping the pump.
C
chase85Aug 6, 2025
How to fix a Kärcher Pressure Washer when the pump runs but does not transport?
- V
  Victor SnyderAug 6, 2025
  If the Kärcher Pressure Washer pump runs but doesn't transport fluid, it could be due to a few reasons. There might be air in the pump; try repeatedly unplugging and plugging in the mains plug until the fluid is drawn. Also, the suction area could be blocked, so pull out the mains plug and clean the suction area. If you are in manual mode, ensure the water level is above the minimum; if it's not, immerse the pump deeper into the fluid.
D
Deborah WilsonAug 13, 2025
What to do if the pumping capacity is reducing on my Kärcher SP 2 Flat?
- A
  alicia93Aug 13, 2025
  If the pumping capacity of your Kärcher Pressure Washer is reducing, it's possible that the suction area is blocked. To resolve this, pull out the mains plug and clean the suction area.
O
osteeleAug 21, 2025
How to fix a Kärcher SP 2 Flat Quick-Connect that won't open or close?
- T
  Tracy GreenAug 21, 2025
  If the Quick-Connect on your Kärcher Pressure Washer cannot be opened or closed, it might be due to soiling in the plug system. Remove and clean the clip to resolve this issue.

Kärcher SP 2 Flat Specifications

General

AC input voltage	230-240 V
Power source type	AC
AC input frequency	50 Hz
Flow rate	6000 l/h
Motor power	- hp
Residual water level	1 mm
Maximum delivery height	5 m
Depth of immersion (max)	7 m
Initial water level (min)	7 mm
Maximum input water temperature	35 °C
Product color	Black, Yellow
Carrying handle(s)	Yes
Quantity	1