EasyManuals Logo

Kärcher SV 7 Operating Instructions

Kärcher SV 7
Go to English
412 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
– 10
Note
Regular tap water can be used.
As water naturally contains lime, which can
lead to formation of scale over time, it is
recommended to use a mixture that con-
sists of 50% tap water and 50% distilled
water.
ATTENTION
Material damage due to incor-
rect filling of the water tank.
Do not use condensation wa-
ter from the drier!
Do not fill with detergent or
other additives (for example
fragrances)!
Do not use pure distilled wa-
ter! Max. 50% distilled water
and 50% tap water.
Do not use collected rain wa-
ter!
Illustration
Pull the filler neck of the water tank to-
wards the outside.
Illustration
Illustration
Fill the water tank with approx. 0.5 litres
of water until the float, which indicates
the maximum filling level, can be seen.
Close the water tank.
Note
The steam boiler is automatically supplied
with water from the water tank. Prior to the
initial start-up, the water tank must be filled
twice.
ATTENTION
Material damage due to empty
water filter container.
Ensure that the water filter
container is always filled dur-
ing operation.
Illustration
Lift the handle of the water container.
Pull out the water filter container.
Illustration
Turn the handle towards the back.
Illustration
Remove the water filter insert.
Illustration
Fill the water filter container with tap
water until the water level indicator
MAX H
2
O is covered.
Add one cap full of the defoaming liquid
(FoamStop) to the water filter reservoir.
Illustration
Reinsert the water filter insert into the
water filter container.
Illustration
Move the handle to its original position
until it locks in place.
Illustration
Insert the water filter container into the
appliance using the handle.
Note: The functioning of the vacuum clean-
er is based on the whirling of the suction air
in the water filter. In the process, sucked-in
materials and deposits of cleaning agents
from floors get collected in the water bath.
This can sometimes lead to the formation of
foam. It is necessary to add a capful of the
defoamer liquid to the water bath to avoid
this situation. Slight foam formation is nor-
mal and does not hamper the functioning of
the machine.
Preparing the Appliance
Filling the Water Reservoir
Filling the water filter container
24 EN

Table of Contents

Other manuals for Kärcher SV 7

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kärcher SV 7 and is the answer not in the manual?

Kärcher SV 7 Specifications

General IconGeneral
TypeCylinder steam cleaner
Capacity1.2 L
Cord length6 m
Product colorBlack, Silver, Yellow
Boiler power1100 W
AC input voltage220 - 240 V
AC input frequency50 - 60 Hz
Ready time5 min
Steam pressure4 bar
Adjustable steamYes
Cleaning surfacesCarpet, Hard floor, Laminate, Tiles
Continuous steam performance65 g/min
Steam-ready light-
Weight and Dimensions IconWeight and Dimensions
Depth510 mm
Width330 mm
Height340 mm
Weight9100 g
Package weight15600 g

Related product manuals