Need help?Do you have a question about the KaVo ORTHOPANTOMOGAPH OP 2D and is the answer not in the manual?
General| Imaging Technology | Digital |
|---|---|
| Exposure Parameters | Adjustable |
| X-ray Generator | High-frequency |
| Programs | Panoramic |
| Type | Panoramic X-ray |
| Image Resolution | High Resolution |
| Exposure Time | Adjustable |
Details essential safety, electrical, and mechanical precautions for servicing the unit.
Outlines essential annual tests and inspections for ensuring correct and safe operation.
Covers the L1800 generator board, crucial for X-ray generation, including high voltage warnings.
Outlines fundamental troubleshooting steps such as restarting, checking error codes, boards, and cables.
Addresses frequently encountered problems like unit not powering on, display issues, and control panel failures.
Lists and explains various system and user error codes that appear on the unit's main control panel.
Discusses causes for poor image quality, including positioning, alignment, and calibration issues.
Guide on how to open and use the S2terminal utility for unit testing and configuration.
Details various service commands for calibration, diagnostics, and unit configuration.
Detailed procedure for replacing the tubehead, including required tools and steps.
Post-replacement steps for calibrating the tubehead and verifying unit alignment.
Steps for replacing the CCD sensor, including necessary post-replacement alignment.
General procedure for replacing circuit boards, including safety precautions and connection details.
Detailed procedure for replacing the z-motor, including safety precautions and access instructions.
Procedure for checking and aligning the CCD sensor for optimal image capture.
Steps to adjust the vertical position of the X-ray beam for correct image framing.
Procedure to check and adjust the collimator for proper beam shaping and positioning.
To Next Page