SYMPTOM: Programs won't load or execute.
PROBABLE CAUSES AND REMEDIES:
1.
No AC po
t
wer. Be sure that the power cord is plugged in. Check the power
switch and any switches controlling the wall outlet.
2.
No video display. Adjust the brightness control on the rear panel.
3.
Disk drive door not closed properly.
4.
Diskette in drive doesn't contain CP/M. Put the CP/M diskette into drive A
and the diskette which isn't loading into drive B. Type: SYSGEN
Follow the prompts.
5.
Diskette isn't the one expected by the operating program.
6.
Diskette isn't in the drive correctly (label side should be up, seam side down,
and write protect notch at left).
7.
Diskette has been damaged. Try making another copy from your master.
8.
Incorrect response to a prompt or invalid menu selection; check for error
message from program.
9.
You're asking the program to do something it can't. When all else fails, read
your manual.
42
To Next Page
Loading...
