COPYING MASTER DISKETTES
Before you can use the software which came with your KAYPRO, you must copy
each of the master diskettes.
The general process is the same every time you copy a diskette.
The COPY program is on the CP/M diskette. To use it:
1.
Turn on the KAYPRO, using the power switch on the back panel of the
computer.
2.
Insert the CP/M diskette into drive A with the label facing up.
3.
Close the drive door, and wait until the display .shows the CP/M version
number and the A> prompt.
4.
To run the copy program, type: COPY
Press the RETURN key.
5.
Put a new, empty diskette into drive B with the write-protect notch at the left.
6.
When the main menu appears, choose the COPY option by typing: c
7.
When you have read the message on the screen, remove the CP/M
diskette from drive A (unless you are copying the CP/M diskette itself).
8.
Insert the diskette that you want to copy into drive A.
9.
To start the copying process, press the RETURN key.
The track numbers will display as they are being copied (00 through 39
on the KAYPRO 2 and 00 through 79 on the KAYPRO 4).
When the last track has been copied, there will appear a list of programs
which are on the new diskette.
28
To Next Page
Loading...
