kayse LS30 - Page 17

To Next Page

To Previous Page

LS30 CONTROLLER INSTALLATION AND OPERATING GUIDE

4.3.2 'r1.of' Parameter

For relay 1 it is the parameter determining reset value. It de-

termines at which point the devices connected to the adjust-

ed value relay 1 will stop.

4.3.3 'r2.on' Parameter

For relay 2 it is the parameter determining set value. It deter-

mines at which point the devices connected to the adjusted

value relay 2 will start.

4.3.4 'r2.of' Parameter

For relay 2 it is the parameter determining reset value. It de-

termines at which point the devices connected to the adjust-

ed value relay 2 will stop.

4.3.5 'r3.on' Parameter

For relay 3 it is the parameter determining set value. It deter-

mines at which point the devices connected to the adjusted

value relay 3 will start.

4.3.5 'r3.of' Parameter

For relay 3 it is the parameter determining reset value. It de-

termines at which point the devices connected to the adjust-

ed value relay 3 will stop.

Note: Relay on and o values for the relay not to be operated

should be adjusted as '0'. For example if relay 3 should not be

operated the 'r3.on' and 'r3.of' parameters should be adjusted

as '0'.