kayse LS30 - Page 18

LS30 CONTROLLER INSTALLATION AND OPERATING GUIDE
18
4.3.7 'out' Parameter
It is the parameter determining the type of analog output.
The analog output value is being shipped adjusted at 4-20 mA
at default value. In order to make transion between mA or
V outputs the dip switch back of device should be replaced
together with 'Output' parameter.
4.3.8 'Addr' Parameter
It is the addressing parameter with RS485 Modbus serial com-
municaon protocol.
According to Adjustment Field;
4-20 : Adjusts the output values as 4-20 mA,
0-10 : Adjusts the output values as 0-10 V,
20-4 : Adjusts the output values as 20-4 mA,
10-0 : Adjusts the output values as 10-0 V,
DIP SW
mA
5
4
3
2
1
DIP SW
V
5
4
3
2
1