kayse LS30 - Sensor Reference Calibration

LS30 CONTROLLER INSTALLATION AND OPERATING GUIDE
20
4.3.10 'Hı' Parameter
It is related with upper scale value of the level indicaons in-
dicated at main operang screen. While liquid level is at maxi-
mum the value to be indicated on screen is determined with
this parameter. This parameter should be adjusted lower than
'Lo' parameter value as an operaon principle.
'Hi' parameter is shipped by adjusng 100 default value. By
this means the depot level can be traced on screen in per-
centage. When the units like liter, cubic meter, kilogram, tons,
meter etc. type of dierent measurement units will be used
by increasing 'Hi' parameter, it may be used in dierent opera-
on ways. For example for a depot with a 5m height if the 'Hi'
parameter is adjusted as 5000 the water level can be traced
in mm.
5. ADJUSTMENT of SENSOR REFERENCE VALUES
The sensor reference values are adjusted with a default value to
give min. 0% scale value, 100% scale level at max. and shipped.
For healthy level measurement reference values should be ad-
justed accurately.
Note: If contrary isn't menoned in this guide don't change references.
4.3.11 'dot' Parameter
It is used to indicate the decimal values of the screen. Aer
the stop decimal value of single digit can be indicated.
(For example 56,4)
According to Adjustment Field;
0 : No decimal value is indicated,
1 : Single digit decimal value is indicated,