kayse LS30 - LS30 Sensor Calibration

LS30 CONTROLLER INSTALLATION AND OPERATING GUIDE
21
The oat is moved
to lowest point
When reference menu is entered parameter transions should
be made rapidly. In contrary in a short while as the device will
return to main operang screen automacally the adjustments
can not be made accurately. For this reason before transion to
this transacon preparaon should be made.
5.1 Adjustment of Reference Value of LS30 Controller at LS30
Level Control Equipments
When the reference values of LS30 Controller is being adjusted
that has been connected to LS30 Level Control Equipments, by
removing the LS30 Level Control Equipments from depot its
oat shuld be taken at a place where it can move easily and
rapidly by hand,
The oat is moved to lowest point,
•
•
LS30
Level Control Equipment