13
4.3.4 Door Lock Time
Door lock time setup includes hold time and over time setup.
Step 1. In A&C setup, press【↑】 key or 【↓】key, select door lock time setup and press
【√】key.
Step 2. Press【←】key to delete original data, input hold time and over time, press 【√】
key.
System prompt setup is successful.
Door lock hold time is the time door remains open after user swipe card. If the door
remains open exceeding “over time”, it will send alarm.
4.3.5 Alarm
User can enable or disable alarm, system alarm includes intrusion, anti-pass back, duress
card, door sensor and door timed out. Please refer to Chart 4- 3.
Alarm Type Note
Intrusion Enter without valid card swiping or password, it will
generate an alarm.
Anti-pass back Must swipe card when enter/exit, otherwise it will
generate an alarm.
Duress Card Enter with duress card, it will generate an alarm.
Door Sensor When A&C device is damaged, it will generate an
alarm.
Door Lock Time Setup
Hold Time： 2000 MS
Over Time： 60 S
Unlock Mode Setup
Card
To Next Page