11
ECCOS DELAY/LOOPER
TRAILS OR TRUE BYPASS
STATUS LIGHTS
STEREO, PING PONG, ETC.
RUNAWAY FEEDBACK OSCILLATOR
When bypassing the unit, the ECCOS can be set to let delay trails repeat or to stop them immediately. No trails is
equivalent to true bypass; trails requires and uses a top shelf, Keeley Electronics approved output buffer.
TRAILS - Hold BYPASS + Hold TAP for 2 seconds.
The BYPASS And STATUS LEDs will flash two times to show the change was saved. Default setting is true bypass.
Status Light steady = A loop is in memory. Blinks once at the start of a loop.
Looper Light flashing = Loop is playing at half speed.
Bypass and Status Lights flash twice = Loop has been successfully deleted.
Bypass and Status Lights flash twice = Expression controls have been cleared.
Status Light constant blink = You are in expression pedal assign / unassign mode.
A slight stereo field is created when simultaneously using both outputs. The Stereo Out is slightly modulated to
give a stereo impression. True stereo ping pong only occurs when using two amplifiers. Stereo ping pong only
works in subdivisions.
Note: In stereo mode, the quarter note is on the stereo output and the subdivision is on the mono output.
Press and hold TAP to engage maximum feedback - Perfect for endless repeats at the press of a button!
To adjust the volume of the runaway feedback oscillator, hold TAP and adjust the FDBK knob while in delay mode.
Note: This can only be set with the FDBK knob, and not with an expression pedal.
To Next Page
Loading...
Need help?
General