9
HYDRA STEREO REVERB & TREMOLO
EXPRESSION PEDAL INPUT
You must use a TRS (stereo) expression pedal with the
HYDRA. If you use a mono cable (or volume pedal), the
HYDRA will not power on.
When a TRS (stereo) expression pedal is inserted, the
expression pedal defaults to controlling the RATE control of
the TREMOLO.
Note: Plugging a mono cable into the TRS EXP. PEDAL jack
will allow the control of the Tap Tempo.
CLEAR ALL EXPRESSION SETTINGS
To clear ALL expression pedal settings, enter Expression
Pedal Mode by holding the COLOR knob for 2 seconds. Once
in Expression Pedal Mode, hold TREMOLO footswitch for 2
seconds to clear ALL expression pedal settings and reset
them to default. Once finished, exit Expression Pedal Mode
by holding the COLOR knob for 2 seconds.
FACTORY RESET
Hold down the COLOR knob + TREMOLO + REVERB
footswitches while applying power to the unit.
All LEDs will flash in succession and all controls, secondary
controls, modes, memory and presets will
return to default settings.
You will see all of the lights on the HYDRA cycle, indicating
that the Factory Reset is complete.
Note: When making these adjustments, it helps to place the
HYDRA on a flat surface, such as a pedalboard or a table top.
EXPRESSION PEDAL USE
TO ASSIGN A PARAMETER
1. Hold COLOR knob for 2 seconds to enter Expression Mode.
2. Set connected expression pedal to heel-down.
3. Turn a HYDRA control knob to the desired
heel-down setting.
4. Set the expression pedal to toe-down.
5. Turn the same control knob to the desired
toe-down position.
6. Hold COLOR knob for 2 seconds to save your settings.
Note: You can set multiple parameters at once to be
controlled with your expression pedal. You can set partial
ranges, reassign ranges, or even reverse heel/toe positions in
this mode. The sky is the limit!
TO UNASSIGN A PARAMETER
1. Hold COLOR knob for 2 seconds to enter Expression Mode.
2. Set connected expression pedal to heel-down.
3. Turn each knob a small amount to let the HYDRA know
you don’t want the control to be ‘expression controlled’.
Don’t touch controls still assigned to the expression pedal.
4. Set the expression pedal to toe-down.
5. Hold the COLOR knob for 2 seconds to unassign and save.
Note: Any parameters that were not moved will maintain
their previous expression status.
Note: You can save expression pedal setting to any of the 3
HYDRA preset locations.
To Next Page
Loading...
Need help?
General
