3.3 Set-up 3.3
CHANGING THE BLADE HOLDER
Before removing a blade holder make sure the blade has been removed or guarded as
appropriate.
Loosen both of the knurled screws
A
by two turns, raise the blade holder to align the
clearance holes with the screw heads
A
and detach the blade holder. Reverse the
procedure to refit or replace a blade holder and finger tighten the screws.
A A
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
To Next Page
Loading...
Need help?
General
