To Next PageTo Next Page
Need help?Do you have a question about the KEENCUT EXCALIBUR 5000 and is the answer not in the manual?
General| Cutting Thickness | 13 mm |
|---|---|
| Maximum Material Thickness | 13 mm |
| Cut Length | 5000 mm |
| Material Compatibility | Foam board, Glass, Paper, PVC |
| Overall Length | 5200 mm |
Adjusts the telescopic legs to the desired length for machine setup.
Details steps to prepare the main body before attaching the squaring arm.
Guides the process of attaching the squaring arm to the machine body.
Instructions for attaching the wall mounting bracket for stability.
Steps for installing the optional free-standing kit for machine support.
Attaches the left side backing panels to the machine structure.
Attaches the right side backing panels to the machine structure.
Procedure to verify the machine's 90-degree alignment for accurate cuts.
Corrects any misalignment to ensure the machine is perfectly square.
Attaches and trims vertical measurement rules for accurate scaling.
Calibrates the scales on the squaring arm for precise measurements.
Attaches and trims the sight-line strip for a precise cutting guide.
Explains how to use the clamping system to secure materials for cutting.
Details the multi-tool cutter head and the counterbalance for model 5000.
How to select, use, and change the cutting blade.
Instructions for using the scoring blade for plastics and scoring.
Guides on using and changing the glass cutter for scoring glass.
Instructions for using the twin wheel cutter for rigid materials.
Recommends regular cleaning of the machine components.
Details on cleaning and lubricating the machine's slideway.
Procedures for adjusting the sliding bearings for proper cutter head movement.
How to adjust the clamp pressure for optimal material holding.
