Keiser M3 - Flywheel, Hub, and Hub Cap Assembly; Preparing and Removing Components; Installing Flywheel and Securing Hub Cap

Assembling Flywheel, Hub, and Hub Cap
Step 1: Before starting the assembly of the ywheel, hub, and hub cap, make sure that the shifter lever is in the
downward position.
NOTE: Not following this step may scratch the ywheel.
Step 2: Remove the plastic wrapping from around the axle, hub, and hub cap. Remove the hub cap. Obtain the 5 socket
head cap screws (M6x1 X 20 SS) and 5mm Allen wrench. Remove the ywheel from its foam envelope.
NOTE: Use the foam envelope to handle the ywheel during assembly.
Step 3: Carefully slide the ywheel between the two magnets and onto the hub at the same time. Make sure that the
ywheel is ush against the hub and align the screw holes.
Step 4: Holding the ywheel in position with one hand, install the hubcap and align the screw holes. Install the socket
head cap screws (M6x1 X 20 SS). Using the 5mm Allen wrench, tighten the screws in a star pattern until snug.
1
2
3
4
9